How to Use
1. Turn On
- Use the back switch to turn on the CNC
- The Fron-Button shows the status of the machine and is used for stand by, but because of the USB Connection, always use the back-button for tuning on and of the machine
2. Home
You should always home the machine before milling, (even after starting it as a good practice)!
- To do that, open makera controller:
- Connect the software via USB on the top left corner:
- Go to the side panel and press 'HOME':
| Side Panel Button on the |
Virtual Controller with 'HOME' in the middle |
|---|---|
 |
 |
3. Fasten the Workpiece
Then use the controller to move the bed thowards you and fasten your workpiece:
| Type of fastening | Example |
|---|---|
| Clamps Place the clamps on the bad and tighten the workpiece with them |
  |
| Tape on a flat workpiece, place some tape on the bottom equally and just stick it onto the bed |
 |
| Screws | TODO |
| Vacuum | TODO |
4. Zero
Then the zero