Audio Tone Control

Thore Lencer, Prof. Dr.-Ing. Ralf Sommer
GaSt Praxisseminar WS 25/26
Probably our most complex double sided PCB so far.
Size ~60x50mm
We are working on soldering this board with our Reflow-oven.
We want to try making the solder-paste stencil with our vinyl-cutter:
Above is a screenshot from GoSign, our software for the Summa S3 T75.
This is an attempt with a speed of 10mm/s instead of 800mm/s:
The first stencil looks very promising!
Reflow soldering
Placing all components:
Good settings for perfect TSSOP package and 0,4mm traces copper milling: 0.2mm v bit but insert 0.25mm in modsproject with 0.25 stepover and 4 offsets
Solder mask removal: Solder mask removal bit; Z calibration with multimeter; then step up by 0,12mm and step down slowly if needed; cure UV mask for 5min first, then mill, then final-cure; cut speed 5mm/s; plunge speed 2mm/s, spindle 6000rpm
Drill after solder mask application! Elsewise solder mask gets into the holes and copper can be destroyed when there are thin pad rings